Belt Removal And Replacement

WARNING: Disconnect the spark plug wire and ground it against the engine before performing any repairs or maintenance.

Auger Belts

Remove the plastic belt cover at the front of the engine by removing the two self-tapping screws. See Figure 15.

Drain the gasoline from the snow thrower, or place a piece of plastic film under the gas cap.

Tip the snow thrower up and forward so that it rests on its auger housing.

Engine

Self-Tapping

Screws

Belt Cover

Auger Housing

Figure 15

Remove the six self-tapping screws from the frame cover underneath the snow thrower.

Roll the front and rear auger belts off the auger drive pulley. See Figure 16.

Unhook the idler spring from the hex bolt on the auger housing. See Figure 17.

Back out the stop bolt until the support bracket rests on the auger pulley. See Figure 18.

NOTE: It may be necessary to loosen the six nuts that connect the frame to the auger housing to aid in belt removal.

Lift the rear auger belt from the auger pulley, and slip the belt between the support bracket and the auger pulley. See Figure 17. Repeat this step for the front auger belt.

Replace both auger drive belts by following instructions in reverse order.

 

Wheel

 

Drive

 

Pulley

Auger

 

Drive

Wheel

Pulley

Drive

Idler

Belt

 

Pulley

Idler

 

Pulley

Auger

Drive

Belts

Frame

Figure 16

NOTE: If you placed plastic film under the gas cap, be certain to remove it before operating the snow thrower.

Drive Belt

Follow the first four steps of the instructions for servicing the auger belts.

Pull the idler pulley up, and lift the belt off the wheel drive pulley and friction wheel disc. See Figure 17.

Back out the stop bolt until the support bracket rests on the auger pulley. See Figure 18.

Slip the belt between the friction wheel and drive disc. See Figure 18. Remove and replace the belt. Reassemble following the instructions in reverse order.

NOTE: The support bracket must rest on the stop bolt after the new belt has been assembled. See Figure 18.

Support

Bracket

Rear

 

Auger

Frame

Belt

Front

Auger

Belt

AugerSupport

Pulley Idler Auger Bracket

Spring Housing Spring

Figure 17

14

Page 14
Image 14
Cub Cadet 724 STE, 926 STE manual Belt Removal And Replacement, Auger Belts, Drive Belt