ELECTRICAL SYSTEM
Adjusting the
Loosen the
VOLTAGE REGULATOR
A satisfactory generator charging rate is maintained by the voltage regulator. If the regulator fails to operate correctly, see your I nternational Harvesterdealer
Move the generator away from the engine until the tension on the belt is correct.
NOTE: Under no circumstances should a pry bar be used on the
Tighten mounting bolts and brace bolt.
Removing and Replacing the
1.Mounting bolts2.
Motor generator brace bolt3. Motor generator belt
Replace the
NOTE: If tractor is equil with rotary mower I drive belt must also be removed when replacing generator belt.
NOTE: Never place a jumper lead between, or accidentally bridge, the "BAT" terminal and the "F" terminal on the regulator, as this will damage the regu lator.
LIGHTS
Lights are optional on all models except the Models 149 and 169.
The headlights are
"SPECIFICATIONS" when replacement is neces-
sary.
To replace the taillight lamp, remove the lens from
the taillight and r~place. Refer to
FUSE (Electric Lighting)
Always use the same capacity fuse for replacement. Refer to "Specifications". If the lights fail, check the fuse.
The fuse is located in a fuse housing in the line at the back of the instrument panel.
To install a new fuse, press in on the fuse housing cap and turn counterclockwise to remove it from the fuse housing. Remove the old fuse and replace it with a new one. Then reassemble the cap to the housing. Remove the fuel tank if necessary to reach the fuse.
Before working on any part of the electrical system, disconnect the battery ground cable at the battery negative
23
pped