Cub Cadet 928 SWE, 945 SWE warranty Service, Belt Removal Preparation, Auger Belt Replacement

Service

7

Belt Replacement

Belt Removal Preparation

1.Disconnect the chute crank assembly at the discharge chute end by removing the hairpin clip and the flat washer. Refer to Figure 7-1.

Figure 7-1

2.Removethehexscrewsandlocknutssecuringtheforward end of the support tubes to the back of the auger housing, and pivot the tubes upward.

3.Removetheplasticbeltcoveronthefrontoftheengineby removing the three self-tapping screws. See Figure 7-2.

Figure 7-2

4.Loosen the bolt shown in Figure 7-3 securing the belt keeper bracket and remove the other bolt. Push the belt keeper bracket up off the engine pulley. Refer to

Figure 7-3.

Remove

Loosen

Figure 7-3

Auger Belt Replacement

To remove and replace your snow thrower’s auger belt, proceed as follows:

1.Remove the hairpin clip and flat washer from the ferrule in order to disconnect the auger idler rod from the brake bracket assembly. See Figure 7-4.

NOTE: Make sure to maintain the location of the ferrule on the idler rod.

Figure 7-4

19