Cub Cadet 928 SWE Two-Way Chute Control, Chute Directional Control, Wheel Steering Controls

Two-Way Chute Control™

The two-way chute control is located on the left side of the dash panel and is used to control the distance of snow discharge from the chute.

•To change the upper chute angle to control the distance that snow is thrown, pivot the lever forward or backward.

•Move the lever forward to pivot the upper chute down and reduce the distance snow is thrown.

CHUTE DIRECTIONAL CONTROL

DISCHARGE	DISCHARGE
LEFT	RIGHT

CHUTE TILT

DOWN

CHUTE TILT

UP

•Move the lever rearward to pivot the upper chute upward and increase the distance snow is thrown

Chute Directional Control

The chute directional control is located on the left side of the snow thrower.

•To change the direction in which snow is thrown, crank clockwise to discharge to the left and counterclockwise to discharge to the right.

Wheel Steering Controls

The left and right wheel steering controls are located on the underside of the handles. Squeeze the right control to turn right; squeeze the left control to turn left.

NOTE: Operate the snow thrower in open areas until you are familiar with these controls.

Chute Clean-Out Tool

Warning! Never use your hands to clear a clogged chute assembly. Shut off engine and remain behind handles until all moving parts have stopped

before unclogging.

The chute clean-out tool is conveniently fastened to the rear of the auger housing with a mounting clip. Should snow and ice become lodged in the chute assembly during operation, proceed as follows to safely clean the chute assembly and chute opening:

1.Release both the Auger Control and the Drive Control.

2.Stop the engine by removing the ignition key.

3.Remove the clean-out tool from the clip which secures it to the rear of the auger housing.

4.Use the shovel-shaped end of the clean-out tool to dislodge and scoop any snow and ice which has formed in and near the chute assembly.

5.Refasten the clean-out tool to the mounting clip on the rear of the auger housing, reinsert the ignition key and start the snow thrower’s engine.

6.While standing in the operator’s position (behind the snow thrower), engage the auger control for a few seconds to clear any remaining snow and ice from the chute assembly.

Head Light

It can be tilted by loosening the screws on the side of its housing, position the light in the desired location and then retighten the screws.

Section 4 — Controls and Features

13