4.While holding the free end of the oil drain hose over the oil collection container, unscrew the square head hose plug from the end of the hose. See Figure
Oil Drain Hose
Square Head Plug
Figure
5.After draining the oil, wipe any residual oil from the oil drain hose. Thread the square head plug into the drain hose fitting and fully tighten the plug.
6.Replace the oil filter, and refill the engine with new oil as instructed in the Kohler Owner’s Manual.
7.
To refill the oil,
NOTE: Maintenance, repair, or replacement of the emission control devices and systems which are being done at owner’s expense may be performed by any engine repair establishment or individual.
Warranty repairs must be performed by a Cub Cadet Dealer.
Hydrostatic Transmission Oil
Checking the Hydrostatic Transmission Oil
The dipstick to check the hydrostatic transmission oil level is located on the back of the mower on the upper section of the frame. Refer to the Controls & Features section of this manual.
1.Remove the dipstick and check the level. See Figure
F
Full
OK
A
Add
Figure
2.If the level is above the “ADD” level and in the “OK” range, it is not necessary to add any transmission oil. If the level is at or below the “ADD” level add transmission oil into the oil fill port until the level is in the “OK” range. For best results, fill to the “FULL” mark on the dipstick as opposed to adding a specific volume of oil. Do NOT overfill.
NOTE: The approved fluid is Cub Cadet Drive System Fluid Plus. (1 quart — Part No.
3.Reinstall the transmission oil fill plug/dipstick securely into the oil fill port.
4.Start the engine and allow it to run for a few minutes. Shut the engine off, then check for leaks and
Changing the Hydrostatic Transmission Oil
CAUTION: Never overfill the transmission case. Damage or leakage may result if the oil level in the transmission case is below the “ADD” mark or over the “FULL” mark of the dipstick.
1.Place the tractor on a level surface and engage the brake pedal lock. Stop the tractor engine and remove the ignition key.
2.Clean the area around the transmission drain plug to prevent debris from entering the transmission case.
Section 6 — Maintenance & Adjustments |
| 19 |
| ||
|
|
|