Headlights

Refer to Replacement Parts section when replacement of head lamp bulbs is necessary.

Replace headlight bulbs as follows:

1.Fully raise the hood of the tractor.

2.Unplug the wire harness leads from the headlight socket terminals. Note which wire connects to each terminal before disconnecting.

3.Rotate the socket assembly approximately 1⁄4 turn to align the socket tab with the reflector housing notch; then withdraw the bulb and socket assembly from the reflector housing. See Figure 7-3.

Terminal

Socket Tab

Socket

Reflector Housing Reflector Notch

Figure 7-3

4.Push the bulb inward and turn counterclockwise to remove from the socket.

5.Align a locking post of the bulb base with the notch in the socket, then push the bulb inward and turn clockwise to lock. See Figure 7-3.

6.Align the socket tab with the notch of the reflector housing; then push the socket inward and turn as necessary to lock the socket in the housing:

7.Connect the wire harness leads to the appropriate socket terminals.

Fuses

Always use the same capacity fuse for replacement. If the electrical system does not function, check the fuses.

To replace a fuse, pull the old fuse from the fuse holder and install the new fuse.

Section 7 — Service

 

25