Cub Cadet OEM-390-679 Operating Your Snow Thrower, Know Your Snow Thrower, R R1, Shift Lever

4

Operating

Your Snow

Thrower

WARNING

Read, understand, and follow all instruc- tions and warnings on the machine and in this manual before operating.

Know Your Snow Thrower

Drive Control	Heated Handle Switch (en option)†
		Shift Lever
		Two-Way Chute Control
Headlights		Auger Control
Chute Assembly		Wheel Steering Control
		Chute Directional Control
Clean-Out Tool
	Choke	Engine Controls
	Control
			Gas Cap
	Primer
				Oil Fill
				Electric Start
				Button
				(optional)
	Safety
	Key
	Skid Shoe
				Electric Starter
		Recoil Starter	Rocker	Outlet
				(optional)
† If Equipped		Handle
			Switch

Figure 4-1

Use extreme care when handling gasoline. Gasoline is extremely flammable and the vapors are explosive. Never fuel the machine indoors or while the engine is hot or running. Extinguish cigarettes, cigars, pipes and other sources of ignition.

Now that you have set up your snow thrower for opera- tion, get acquainted with its controls and features. These are described below and illustrated on this page. This knowledge will allow you to use your new equipment to its fullest potential.

NOTE: For detailed starting instructions and more information on all engine controls, refer to the separate engine manual packed with your unit.

Shift Lever
The shift lever is located in the center of		6
the handle panel and is used to determine		5
ground speed and direction of travel. It can		4
be moved into any of eight positions.		3
IMPORTANT: Always release drive control		2
before changing speeds.	F	1
Forward: The snow thrower has six
forward (F) speeds. Position one (1) is the	R R1
slowest and position six (6) is the fastest.
Reverse: The snow thrower has two		R2
reverse (R) speeds—R1 is the slower of

the two.

Choke Control

The choke control is found on the top of the engine and is activated by rotating the knob counter clockwise. Activating the choke control closes the choke plate on the carbure- tor and aids in starting the engine.

Primer

Depressing the primer forces fuel directly into the engine’s carburetor to aid in cold-weather starting.

Oil Fill

Engine oil level can be checked and oil added through the oil fill.

Safety Key

The safety key must be pushed in place in order for the engine to start. Pull the safety key out to prevent unauthor- ized use of equipment.

Rocker Switch

The rocker switch is used to stop the engine. The switch must be in the “ON” position in order to start the engine.

10