Steering Wheel

1.Remove the hardware for attaching the steering wheel from beneath the steering wheel cap. Carefully pry off the steering wheel cover to remove the hardware.

2.With the wheels of the tractor pointing straight forward, place the steering wheel over the steering shaft.

3.Place the flat washer and belleville washer over the steering wheel and secure with the hex screw. See Figure 3-3.

Steering Wheel Cover

Install Operator’s Seat

To install the seat proceed as follows:

NOTE: The seat is shipped with the seat switch and seat pan attached. A second person may be needed to hold the seat.

1.Cut any straps securing the seat assembly to the tractor. Remove any packing material.

NOTE: Be careful not to cut the wiring harness connecting the seat and the seat switch in the bottom of the seat.

2.Remove the two shoulder screws in the seat pan as shown in Figure 3-4.

Hex Screw

Steering Wheel

Belleville Washer

Steering Wheel

Column

 

Figure 3-3

 

4.

Place the steering wheel cover over the center of the steering

 

 

wheel and push downward until it “clicks” into place.

Figure 3-4

 

 

 

3.

Rotate the seat into position and secure the seat into place

 

 

with the previously removed shoulder screws. Be careful

 

 

not to crimp or damage the wire harness while installing

 

 

the seat. See Figure 3-5.

Figure 3-5

NOTE: Be sure to push the excess wire from the wire harness into the seat box hole before continuing.

10Section 3— Assembly & Set-Up