Parking Brake/ | PARK BRAKE/ | |||||
Cruise Control Lock Pedal | ||||||
CRUISE CTRL. | ||||||
LOCK PEDAL | ||||||
The parking brake/cruise control lock pedal is |
|
|
|
|
| |
|
|
|
|
| ||
|
|
|
|
| ||
located at the base of the steering column. It |
|
|
|
|
| |
|
|
|
|
| ||
is used to engage the parking brake when the |
|
|
|
|
| |
tractor is at rest. Engaging the lever while the | I23746 | |||||
tractor is in motion allows the tractor to remain | ||||||
|
|
|
|
| ||
at a constant ground speed without applying |
|
|
|
|
| |
pressure to the forward drive pedal. Refer to
the Operation section of this manual for detailed instructions regarding the parking brake as well as the cruise control feature.
NOTE: Cruise control can NOT be engaged at the tractor’s fastest ground speed. If the operator should attempt to do so, the tractor will automatically decelerate to the fastest optimal mowing ground speed
NOTE: The parking brake must be set if the operator leaves the seat with the engine running or the engine will automatically shut off.
WARNING! Never leave a running machine unattended. Always disengage PTO, set parking brake, stop engine and remove key to prevent unintended starting.
Forward Drive Pedal
The forward drive pedal is located on the right side of the tractor, along the running board. Press the forward drive pedal forward to cause the tractor to travel forward. Ground speed is also controlled with the forward drive pedal. The further forward the pedal is pivoted, the faster the tractor will travel. The pedal will return to its original position when it’s not pressed.
Reverse Pedal
The reverse drive pedal is located on the right side of the tractor along the running board. Ground speed is also controlled with the reverse drive pedal. The further downward the pedal is pivoted, the faster the tractor will travel. The pedal will return to its original position when it’s not pressed.
Transmission Bypass Valves
The transmission bypass valves (one for each the RH and LH transmission) are located under the tractor on the back of each transmission inside the rear wheels.
When engaged, the two valves open a bypass within the hydrostatic transmissions, which allows the tractor to be pushed short distances by hand. Refer to the Assembly &
Cup Holder
The cup holder is located on the RH console to the right of the operator’s seat.
Storage Tray
The storage tray is located at the rear of the RH console.
Seat Adjustment Lever
The seat adjustment lever is located below the left side of the seat. The lever allows for adjustment of the fore to aft position of the operator’s seat. Refer to the Assembly &
Section 4 — Controls & Features |
| 15 |
| ||
|
|
|