
PTO (Power
Hour Meter/Indicator Panel
The PTO switch is located on the LH console to the left of the operator’s seat.
The PTO switch operates the electric PTO clutch mounted on the bottom of the engine crankshaft. Pull the switch knob upward to engage the PTO clutch, or push the knob downward to disengage the clutch.
The PTO switch must be in the “disengaged”
The hour meter/indicator panel is located on the LH console to the left of the operator’s seat.
Hour Meter Features
The hour meter records the hours that the tractor has been operated in the digital display (tenths of an hour - right most digit).
BATT. | OIL |
HOURS 1/10
PTO / | PARK |
BLADE | BRAKE |
position when starting the engine.
Transmission Bypass Rods (Not Visible)
The transmission bypass rods (one for each the RH and LH transmission) are located on the rear of the tractor, just inside each rear wheel, below the storage trays.
When engaged, the two rods open a bypass within the hydrostatic transmissions, which allows the tractor to be pushed short distances by hand.
Caution: Never tow your tractor. Towing the tractor with the rear wheels on the ground may cause severe damage to the transmissions.
Cup Holder
The cup holder is located on the LH console to the left of the operator’s seat.
Storage Tray
The storage tray is located at the rear of the LH console.
Seat Adjustment Lever
The seat adjustment lever is located below the front/left of the seat. The lever allows for adjustment of the fore to aft position of the operator’s seat. Refer to the Maintenance & Adjustments section for instructions on adjusting the seat position.
Fuel Valve
The fuel valve is located on the front of the LPG Tank. When turned in a clockwise direction until it stops, it will shut off the flow of fuel to the engine. When turned in a
NOTE: The hour meter is activated whenever the ignition switch is turned to the “ON” position. Keep a record of the actual hours of operation to assure all maintenance procedures are completed according to the instructions in this manual and the engine manual.
When key is turned to the “ON” position, the battery indicator light briefly illuminates and the battery voltage is briefly displayed. The display then changes to the accumulated hours.
The Indicator Monitor will also remind the operator of maintenance intervals for changing the engine oil. The LCD will alternately flash, “CHG” ; “OIL” and the recorded hours for five minutes after every 50 hours of recorded operation. The maintenance interval lasts for two hours (from
Fuel Gauge
Located on the front of the LPG tank, the fuel gauge measures the fuel level in each tank.
|
|
|
| 1/2 |
|
| |
E | 1/4I Z O | NT | L | ||||
| O | R |
| ||||
|
|
|
| F | |||
| H |
|
|
|
| A | |
|
|
|
|
|
| L.P. | |
|
|
|
|
|
|
| |
|
|
|
|
|
|
| GAS |
| V |
|
|
| FUEL | ||
|
|
| L | ||||
|
|
| E |
|
| ||
|
|
|
| A |
| ||
O |
|
| R T IC |
| K | ||
| K | ADD | |||||
|
|
|
|
|
| O |
Section 4 — Controls & Features |
| 13 |
| ||
|
|
|