Enjoy the 2-in-1 coffee plus™
Your Coffee PLUS™ system is designed to let you use the Coffeemaker and Hot Water System separately, or at the same time. Perfect for every occasion.
BEFORE FIRST use
We recommend flushing out both the Coffeemaker and Hot Water System before first use.
Coffeemaker: Fill the reservoir with cold water and follow the directions for Brewing Coffee. Do not add coffee!
Hot Water System: Fill the reservoir to the Max fill line and follow directions for Using the Hot Water System.
Once the system flush is complete, your Coffee PLUS™ system is ready to brew and heat water so you can enjoy Cuisinart at its best!
PROGRAMMING YOUR CoffeeMaker
Setting the Clock
When the Coffeemaker is plugged in, 12:00 will appear.
Turn the Function knob to CLOCK
Hold down the Hour or Minute button until the clock begins flashing. Press either button to select the desired time. Hold buttons down to scroll through the digits, or press and release to advance one digit at a time. When scrolling, the numbers will advance slowly and then speed up. When the number displayed approaches the desired time, press and release to advance one digit at a time. Be sure the PM indicator is on if a PM time is desired.
To finish setting the clock, turn the Function knob to any other setting or simply wait until the numbers stop blinking.
SETTING THE AUTO ON TIME
When you turn the Function knob to PROG,
it displays a previously selected Auto On time, or the default time (12:00pm).
1.Turn the Function knob to PROG
Use the Hour and Minute buttons as above to program your
2.Turn the Function knob to AUTO ON LCD will display the current time.
3.Press and release On/Off button
A blue light indicates that the Coffeemaker is in AUTO ON mode. The blue light around On/ Off will come on when brew cycle begins.
Both lights will turn off when the Keep Warm cycle ends.
NOTE: To start brew time at the same time the next day, simply make sure the Function knob is on AUTO ON and press and release On/Off button once more. The blue Auto On light will turn on.
SETTING THE AUTO OFF TIME
Turn the Function knob to AUTO OFF
Use the Hour and Minute buttons as above to program your Coffeemaker to shut off from 0 to 4 hours after brew cycle is finished.
CHARCOAL WATER FILTER
Your Coffeemaker comes with two charcoal water filters that eliminates chlorine, bad tastes and odors from tap water.
Inserting the Water Filter
•Remove the filters from the polybag and soak them, fully immersed, in cold tap water for 15 minutes.
•Lift the water filter holder out of the water reservoirs from both the Coffeemaker side and Hot Water System side (see diagram, page 5).
•Press down on the filter compartment and pull toward you to open.
•Place filter into the holder and snap
it closed. Be careful – improper placement can tear the filter skin.
•Flush filter by running cold tap water through holes in bottom of compartment for 10 seconds.
•Allow the filter to drain completely.
•Slide the water filter holder back into the channel in the water reservoir, pushing it down to the base of the unit.
NOTE: We recommend changing the water filter every 60 days or after 60 uses, and more often if you have hard water.
Replacement filters can be purchased in stores, by calling Cuisinart Customer Service, or at www. cuisinart.com.
Hot Water Charcoal | Coffeemaker Charcoal |
Water Filter | Water Filter |
7