Brewing COFFEE
Follow instructions in Before First Use on previous page.
1.Insert charcoal water filter
Follow directions for the preparation and insertion of the filter on page 7.
2.Fill the water reservoir
Open the Coffeemaker reservoir cover by lifting it up. Pour in the desired amount of water using the water level indicator located at the side of the coffeemaker.
3.Set preferences
a.Push the
b.Turn the Carafe Temperature dial to Low (L), Medium (M), or High (H) and heater plate will keep coffee at the temperature you select.
4.Add the ground coffee
Remove the filter basket by grasping the handle and lifting straight up. Insert a #4 paper filter or permanent filter. Be sure that a paper filter is completely open and fully inserted in the basket. It may help to fold and flatten the seams of a paper filter beforehand. Add 1 level scoop of ground coffee per cup. Adjust the amount according to taste.
NOTE: The maximum capacity for ground coffee is 15 tablespoons for this coffeemaker. Exceeding this amount may cause overflow if the coffee is too finely ground.
Replace the filter basket in the filter basket holder and press firmly on cover to be sure it closes securely.
5.Before brewing coffee
Make sure the glass carafe is in position on the heater plate and the top cover is closed. Plug the cord into an electrical outlet.
6.Power unit
Turn the Function knob to brew, press the On/Off button, and the blue indicator light will turn on. Or, set the Auto On function (see page 7) and the Auto On indicator will light.
7.After brewing
When the brewing cycle has been completed, five beeps will sound. Coffee will continue to stream from the filter for several seconds.
Note: Reservoir cover may be hot during and directly after brewing. Wait at least 10 minutes before opening.
Brew Pause™ Feature
This feature interrupts the flow of coffee from the basket to let you pour that first cup
NOTE: Removing carafe for more than 20 seconds may cause filter basket to overflow.
using the hot water system
Follow instructions in Before First Use on previous page.
1.Insert charcoal water filter
Follow directions for the preparation and insertion of the filter on page 7.
2.Fill the water reservoir
Open the Hot Water reservoir cover by lifting it up. Fill the reservoir with water, making sure not to fill above the Max fill line.
3.Heating
Press the On/Off button on the Hot Water side of your unit. The blue On indicator around the On/Off button will light. The Water Ready indicator will flash while the unit is heating. Once the unit has heated, the Water Ready indicator will become solid.
4.Dispensing water
To dispense water, be sure the safety switch, which is located below the lever, is in the unlocked position. Simply slide the safety switch to the left to unlock. Then place a cup on the drip tray and press the lever down – the unit dispenses up to 13 ounces of hot water at a time. If desired, return the safety lock to the locked position (to the right) after dispensing water.
NOTE: You can remove the drip tray to accommodate tall mugs.
5.After dispensing
The heater will immediately begin heating more water. The Water Ready indicator will again flash until water reaches serving temperature.
NOTE: The red Add Water indicator will light if more water is needed.
6.Turning off Hot Water System
To turn off your Hot Water System at any time, press the On/Off button. The On indicator will turn off, but the Water Ready indicator will remain lit until water has cooled below serving temperature.
8
