The rice cooker will switch to the Warm cycle when it has finished cooking. At this time, you may stir in chopped raw vegetables such as green onions, slivered snow peas, shredded carrots, or even grape tomatoes to add texture to the dish

– they will warm while the rice is resting, and if served in 5 to 10 minutes will retain their unique texture.

The rice cooker can be used to prepare com- mercially packaged pilafs, rice and grain mixes. Some packages will come with generic rice cooker instructions, or they may be found on the websites of the manufacturers. If the package has a sautéing step, do it right in the rice cooker bowl. Turn on, add specified amount of butter or oil, add rice/vegetables/meat and sauté accord- ing to package instructions, with the lid on. Add liquid and continue to cook. If the rice is too wet, allow it to remain on Warm for 15 to 20 minutes before serving. If it is too chewy, add up to 1/4 cup more liquid and let stay on Warm until liquid is absorbed (about 15 to 20 minutes).

When measuring rice with your rice cooker cup, level it off with a table knife or spatula as you would flour for baking.

If desired, you may spray your rice cooking bowl with nonstick cooking spray, but this step is not necessary, as it has a nonstick coating.

When rice is placed in the cooking bowl, level it off to a flat layer that covers the entire bottom of the bowl, to ensure that it cooks evenly.

The water you use for cooking rice should be the same water that you drink. If you do not like the taste of your tap water, use bottled or filtered water. The taste of the water will affect the taste of the rice.

For best results, use cold water. Cooking times will vary depending on the temperature of the water being used.

Liquids other than water may be used to cook rice. Use low-fat, low-sodium meat or vegetable stocks/broths. Fish stock or clam broth may be used for seafood-flavored rice.

One to two teaspoons of unsalted butter, olive, vegetable or nut oil will help keep grains of rice separate and prevent boiling over.

If your recipe calls for salt, add and swirl in with the rice paddle or a wooden spoon after adding liquid — then level the rice as evenly as possible.

The rice cooker can be used to steam vegetables, seafood and some meats while cooking the rice. Use our recipes as a guide, then create your own combinations.

When steaming vegetables, clean them and

trim to similar size. Follow Steaming Guide (page 7) for steaming vegetables alone. To steam veg- etables while preparing rice, use steaming guide to time when to add vegetables to steaming tray.

Most vegetables can be added about 10 minutes before rice has finished cooking.

When steaming meats such as poultry or sau- sage, cut all into small, similar sized pieces (such as “finger strips” or 1-inch slices). Arrange in a single layer in the steaming tray, which has been sprayed with cooking spray.

When steaming shrimp, scallops and other sea- food, arrange in a single layer in the steaming tray, which has been sprayed with cooking spray.

When using your rice cooker, plug it in and arrange it on the counter away from the wall and not under hanging cabinets, to prevent steam damage.

The steam vent in the cover should always be placed facing the back of the rice cooker. Lift the lid from the back to the front to prevent steam burns.

One cup of uncooked rice makes approximately three cups of cooked rice.

1 rice cooker cup (filled to the top) = ¾ cup = 12 tablespoons

ASSEMBLY INSTRUCTIONS

To use your Cuisinart® Rice Cooker/Steamer:

1.Carefully unpack the cooker.

2.Rinse the nonstick cooking bowl, steaming tray and lid in warm, soapy water. Rinse well and dry thoroughly.

3.Wipe all interior and exterior surfaces of the rice cooker base with a soft, damp cloth.

4.Place cooking bowl in base of unit.

5.Place steaming tray in cooking bowl with open part facing down.

6.Place the lid on top of the cooking bowl.

7.Do not plug in unit. Your rice cooker is now ready for use.

OPERATION

Cooking Rice

1.Make sure your Cuisinart® Rice Cooker/Steamer is unplugged.

2.Place cooking pot in the stainless steel housing.

3.Measure desired amount of raw rice with the measuring cup provided. Rinse rice if needed. See Guide for Cooking Rice (page 6) for rice-to-water ratios.

4.Choose one of the following ways to add water or stock for cooking:

a.Using the measuring cup provided for rice, measure the appropriate amount of water using standard liquid measuring cup.

See Guide for Cooking Rice.

b. Using the water line inside the cooking pot, add water to the rice inside the bowl up to



Page 4
Image 4
Cuisinart CRC-800 manual Assembly Instructions, Operation