Cuisinart CWC-1200 manual Safeguards, Special Cord SET Instructions

IMPORTANT

SAFEGUARDS

When using an electrical appliance, basic precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including the following:

1.Use this appliance only as described in this manual. Other uses not recommended may cause fire, electric shock or personal injury.

2.This product is intended for household use only.

3.To protect against electric shock, do not immerse unit, plug or cord in water or spray with liquids.

4.Close supervision is necessary when any appliance is used by or near children.

5.Unplug from the outlet when not in use when moving from one location to another, and before cleaning.

6.To disconnect the appliance, grip the plug and pull it from the wall outlet. Never pull by the cord.

7.Do not operate the appliance in the presence of explosives and/or flammable fumes.

8.Do not place the appliance or any of its parts near an open flame, cooking or other heating appliance.

9.Do not operate the appliance with a damaged cord or plug, if the product malfunctions, or if it is dropped or damaged in any manner.

10.The use of attachments not recommended by the manufacturer may be hazardous.

11.Place the unit on a dry level surface.

12.Do not operate if the housing is removed or damaged.

13.A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. Contact a qualified electrician to replace loose or worn outlet.

14.This appliance is designed to be freestanding only, and should not be recessed or built in (fully recessed.)

15.Locate the unit away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct sunlight will affect/alter the outside color of the appliance.

WARNING: To reduce the risk of fire, electric shock or personal injury, unplug or disconnect the appliance from the power supply before servicing.



SAVE THESE INSTRUCTIONS

FOR HOUSEHOLD USE ONLY

SPECIAL CORD SET

INSTRUCTIONS

NOTICE

For your protection, this unit is equipped with a 3-conductor cord set that has a molded

3-prong grounding-type plug, and should be used in combination with a properly connected grounding-type outlet as shown in figure A.

If a grounding-type outlet is not available, an adapter, shown in Figure B, may be obtained so that a 2-slot wall outlet can be used with

a3-prong plug. As shown in Figure C, the adapter must be grounded by attaching its grounding lug under

the screw of the outlet cover plate.

NOTE: Do not remove the grounding prong.

CAUTION: Before using an adapter, it must be

determined that the outlet cover

plate screw is properly grounded.

If in doubt, consult

alicensed electrician. Never use an adapter unless you are

sure it is properly grounded.

Note: Use of an adapter is not permitted in Canada.