Cuisinart DCC1200WE, DCC1200E manual USE of the Appliance, Assembly

DCC1200WE-DCC1200E IB 30/11/04 9:49 Page 12

5

9

6

7

3. USE OF THE APPLIANCE

A. ASSEMBLY

Before the first use or after an extended period of non-use, fill

1the reservoir with cold water up to its maximum level (without coffee nor filter). Put the coffee pot into position, switch on

( + O/I switch) and let the water flow.

2

1. Insert the water filter

10a. Remove the filter from polybag and soak in cold tap water for 15 minutes.

8b. The water filter holder is located inside the water

reservoir, on the left. Open the lid of the coffeemaker

11and remove the water filter holder by lifting it out. To open the water filter holder, place thumbs in slots directly under the arrows and pull open in opposite directions.

12c. Place the filter at the bottom of the water filter holder as indicated on the diagram (Filter will only fit correctly in one end of the holder, that is the right side of the holder when positioned as on the diagram).

d.Close the water filter holder.

13 Filter

e. Re-place the water filter holder in the water reservoir pushing it all the way down to the base of the unit (The side of the holder where the filter is located should be downwards).

It is advised to replace the filter every 60th use approximately.

11