TROUBLESHOOTING GUIDE
Problem: | Solution: |
|
|
Brewer does not have power. | Plug brewer into an independent outlet. |
|
|
| Make sure the brewer is securely plugged in. |
|
|
| Plug into a different outlet. |
|
|
| Confirm the power has been turned on and the LCD is |
| illuminated. |
|
|
Brewer will not brew/doesn’t | Every once in a while an air bubble may get trapped in |
brew a full cup. | the water path. Lift off the reservoir, then put it back into |
| place. |
|
|
| Turn off and unplug the brewer for 30 seconds or more. |
| When you plug the brewer back in, be sure to turn the |
| power back on. |
|
|
| After placing the |
| the handle is pushed down securely and the LCD control |
| panel reads READY. The and buttons, Brew, Hot |
| Water, and Rinse buttons will be illuminated. Then press |
| any of the lit buttons. |
|
|
| Make sure the water reservoir is properly in place, and |
| perform a Rinse cycle. |
|
|
| The exit needle may be clogged (refer to “Cleaning & |
| Maintenance” page 18). |
|
|
| Clean the |
| Maintenance” page 18). |
|
|
The time is not displayed on | You must set the clock (refer to page 15) in order for the |
the LCD control panel. | time to be displayed on the LCD. |
|
|
| If power is interrupted to the brewer, you will need to |
| reset the clock (refer to page 15). |
|
|
Brewer shuts off | Make sure the AUTO OFF and the On/Off time features |
or turns on automatically. | have not been set. To do this, press the Menu button and |
| scroll through the programming options. OFF should be |
| displayed for AUTO OFF timer and On/Off. If OFF is not |
| displayed, you must reset (refer to page 15). |
|
|
The blue light in the water | This indicates the water level in the reservoir is low and |
reservoir is flashing. | water must be added (refer to page 14) in order to brew |
| a full cup. |
|
|
| If sufficient water is in the reservoir, make sure the |
| reservoir is properly seated in the base. |
|
|
Chlorine or mineral taste in | Consider using bottled water, filtered water or the |
coffee. | Cuisinart Charcoal Water Filter. |
|
|
Coffee is too weak or watery. | Reduce the brew size for a |
| (refer to “Programming Your Brew Size” on page 18). |
|
|
| Try an Extra Bold |
| in each portion pack. |
|
|
For more helpful hints see instruction booklet
QUICK REFERENCE GUIDE
Single Serve Brewing System
SETUP
1. Plug the brewer into a grounded outlet. Make sure to remove
all packing tape, stickers and polybags from the brewer. Lift reservoir straight up and away from the brewer and wash
reservoir with water to the max
Follow directions carefully to
2. maximize flavor and performance.
tap water – soak for 15 minutes.
pull toward you to open.
closed. Be careful – improper placement
3. water through lower portion of | Water |
Reservoir | |
Lid | |
| Charcoal |
| Water Filter |
the water reservoir, pushing it down to | Water |
| Reservoir |