INSTALLATION
Unravel the AC cord and connect it to a conveniently located AC outlet having 120V and 60Hz only. The Clock
Display will illuminate and "12:00" will appear in the window. NOTE: If the AC plug does not fit into a nonpolarized
outlet, do not file or cut the wide blade. it is the user's responsibility to have an electrician replace the obsolete outlet.
If the AC cord is disconnected or if there is a power
failure, this electronic clock is designed to continue operating internally (without showing the time on the Clock Display) with a 9 volt battery (not included). To install the battery, press and lift open the compartment cover. Connect the battery to the terminals of the battery snap inside the compartment (use of an alkaline battery is recommended) and snap the battery comaprtment cover back into place.
Be sure to check the condition of the battery periodically by 
disconnecting the AC cord and connecting it again two or three 
minutes later. The preset times should continue operating. If
the present time does not appear, it indicates the battery is dead or not connected properly. The 9 volt battery will keep the internal times accurately for approximately 30 minutes. If the 
power is restored after 30 minutes, the times may need to be reset.
9V
BATTERY PRECAUTIONS
Follow these precautions when using a battery in this device:
1.Use only the size and type of battery specified.
2.Be sure to follow the correct polarity when installing the battery as indicated in the
battery compartment. A reversed battery may cause damage to the device.
3.If the device is not to be used for a long period of time, remove the battery to
prevent damage or injury from possible battery leakage.
4.Do not try to recharge a battery not intended to be recharged; it can overheat and rupture. (Follow battery manufacturer's directions.)
4
