Curtis Mathes CMC19410 Selecting Signal Source, Programming Channels, Storing Channels in Memory

TV OPERATION

Selecting the

Signal Source

The first step in programming your TV/VCR is to select the signal source of your antenna or cable TV system.

1Press MENU to display the menu.

2Press CH▼ until “Setup” is highlighted. Press VOL+.

Programming

the Channels

Storing Channels in Memory

Your TV/VCR can automatically memorize all the channels you receive. Once they are in memory, you can use CH▲ and CH▼ to select channels without using the number buttons.

✔

3Press CH▼ until “Auto Program” is highlighted.

Setup

TV/Line : TV

Air/Cable : Antenna

Auto Program

Add/Erase

Auto Clock Set

Language : English

▲▼ Move œ√Sel. Menu

✔Press MENU at any time to interrupt the programming process and return to normal viewing.

5When the programming process is complete, press CH▲ or CH▼ to scan the channels stored in the TV/VCR’s memory.

Setup

TV/Line : TV

Air/Cable : Antenna

Auto Program

Add/Erase

Auto Clock Set

Language : English

▲▼ Move œ√Sel. Menu

Before you can store channels in

memory, you must have already

selected the signal source. See

“Selecting the Signal Source” on

this page.

1	Press MENU to display the
2	menu.
	Press CH▼ until “Setup” is

4Press VOL– or VOL+ button to begin automatic programming.

Auto Program

ANT 15

: Stop

✔Occasionally the TV/VCR will miss an active channel if the signal is weak or if the channel is off the air when you start programming. Likewise, an unavailable channel may be included in memory if there are stray signals on that channel.

3Press VOL– or VOL+ to select “Antenna,” “Cable STD,” “Cable HRC,” or “Cable IRC.”

✔If your TV/VCR is connected to an antenna, select “Antenna.” If you have cable TV, select “Cable STD,” “Cable HRC,” or “CABLE IRC,” depending on the type of cable system you have.

highlighted. Press VOL+.

Menu

Picture

Time Set

Setup

VCR Setup

Caption

V-chip

▲▼ Move œ√Sel. Exit

The TV/VCR automatically cycles through all the channel numbers and places the available channels in memory. This takes two to three minutes.

Adding and Erasing Channels in Memory

•When entering single-digit channels, press 0 first. For example, to select channel 8, press 0, then 8.

CHAPTER THREE: TV OPERATION 17