CyberData SPA-9000 3.0 Setting up the Speaker for Multicast

Figure 1. Linksys—SIP Diagram

3.0 Setting up the Speaker for Multicast

To set up the speaker for Multicast:

3.1If you are using CyberData speakers as MGROUPS, complete step 1.1 through step 1.13.

3.2Go to Voice => SIP and make a note of the multicast address and port number for page groups (default is 224.168.168.168, port 34567).

3.3Go to the Speaker Setup on the webpage for the speaker and select MGROUPS and DHCP.

3.4After the speaker reboots, get the IP address by activating the DTMF switch on the speaker to announce the new IP address. Enter this new address in the browser to access the speaker's web page.

3.5Select the MGROUPS tab and enter the same multicast address and port number in step 3.1.

3.6Save the settings and reboot the speaker.

3.7Send a page to the speaker by dialing *96 on the Linksys phone and then selecting the dir menu.

3.8Select the corporate directory menu.