HUSB Installation Manual
Doc No.
2.2.Powering On the HUSB
The HUSB is powered through the USB port on the WPT Green Box. To power on the HUSB, connect the USB Cable to the WPT Green Box’s USB port. The HUSB turns on and performs initialization. After initialization, the LCD displays either E0 or the current channel frequency.
The various indicators and characters that are displayed on the LCD display are as shown in the Figure 4.
Figure 4. LCD Display
The front panel of the LCD display is used to perform diagnostics on the HUSB and no user information is displayed.
2.3.Configuring the HUSB
The HUSB is factory configured with Network ID 1. If the network ID of the WPT system is other than 1, the HUSB must be configured with a valid network ID to make it functional.
Note: HUSB has a blank front cover to prevent accidental changes to the configuration settings. The front cover has to be removed to gain access to the display and switches.
Note: The network ID is a single digit number and cannot have a “0” value. To configure the network ID, perform the following:
1.Press and release all three buttons simultaneously. The HUSB enters programming mode, shows the network ID and the first digit starts flashing.
The °F icon is displayed, indicating that the network I D is being programmed.
Press and release all three | Digit will flash when |
buttons simultaneously to | configuring the Network ID |
enter Programming Mode |
|
Page 4 of 6
