Ⅲ.Fitting instructions for camera
| 4 | 1 | Camera mounting platform |
|
| 2 | Terminal block assembly |
|
| 3 | Cable conduits PGB13.5 x 2 |
| 3 | 4 | Captive retainning 1/4” Screws x 3 |
|
| 5 | Heater wires, Ground wire |
1 | 5 2 6 | 6 | Ground wire |
4
Fig.3
(A)(C)
| (E) |
(B) | (D) |
| |
| (G) |
(H)
(G)
(F)
(J)
(C) | (I) |
1.Unscrew the 3 captive Retaining Screws (C) and remove the Housing Cover (A) from the Housing Base (B).
2.Release the 4 Keyhole Screws (F) and then slide and withdraw the Camera Platform
(G) from the Housing Base (B).
3.Mount the Camera (H) onto the Platform (G) using the 1/4” UNC Screw (I) supplied, ensuring that the Insulation Pad (J) is mounted between the Platform and the Camera. Always check that the Camera is firmly attached to the Platform.
4.Connect the Camera power cable to the rear Terminal Block (E) through the
first Cable Conduit (D) referring to the circuit diagram shown in section IV. for the terminal designations.
5.Connect the video cable to the Camera through the second Cable Conduit(D).
IMPORTANT NOTE:
ALWAYS UNPLUG THE TOP SECTION OF THE EARTH WIRE FROM THE BASE WIRE WHEN DISASSEMBLING THE HOUSING. REMEMBER TO PLUG THE TOP AND BOTTOM TOGETHER AGAIN WHEN REASSEMBLING THE HOUSING.
Ⅳ.Wiring diagram
Fig.4 shows the internal wiring diagram of
When necessary, a spare 6 way terminal block is provided at the rear of the enclosure for the camera and lens connections. Circuit identified as follows:
TB.1 | 6 way terminal block |
FTB.1 | Fused terminal block |
FS.1 | 3 Amp. Fuse |
Fig.4 Wiring diagram of DCS-50
ENCLOSURE BASE
| TB.1 |
|
| 1 |
|
| 2 | SPARE |
| 3 | |
| 4 | |
| 5 |
|
| 6 |
|
|
| N |
|
| E |
|
| L |
CHASSIS EARTH | FTB.1 FS.1 |
|
| COVER EARTH |
|
2
