Configure SNMP Trap:
Figure 28. Configure SNMP Trap Setting
Trap authentication fail: When checked, the dialog box of the Trap authentication fail. A trap when authentication fails, the Switch will trap the authentication failure even to the SNMP host.
Power on/power off & threshold above/below: When checked the dialog box of the power on/power off & power threshold above/below. A trap when the PoE port’s power turned on/turned off ; or radio of the system power supply larger than or smaller than the System power Threshold setting.
Add Trap: To create a recipient of SNMP traps generated by the Switch’s SNMP agent, press the “Add Trap” button, and the SNMP Trap Set window will pop up. You can fill in the community name and trap IP address of the remote management station that will serve as the SNMP host for the Switch and check the events selection to enabled selected event traps.
43
