Manuals / D-Link / Computer Equipment / Switch

D-Link DES-802 manual Connecting Power, Network Connections

Models: DES-802

1 37

Page 22

Connecting Power

Power is supplied to the 10/100 Fast Ethernet Switch through an AC power cord. The AC power input voltage ranges from 100 to 240 VAC. A power cable is included with the device.

Figure 6 : Connecting Power

Since the 10/100 Fast Ethernet Switch does not include a power switch, plugging it in to a power outlet will immediately power it on.

Network Connections

If either port on the 10/100 Fast Ethernet Switch is set for full-duplex operation, the device (or LAN) connected to that port should also be set for full-duplex operation. The following sections discuss the requirements for each operating mode.

12	Installation

Page 22

Image 22

D-Link DES-802 manual Connecting Power, Network Connections

Contents

RECYCLABLE DES-802 10/100 Fast Ethernet Switch User’s Guide6DES802...02 Printed In Taiwan Rev. 02 NovemberWichtige Sicherheitshinweise D-Link Offices to Contact for Warranty Service Limited WarrantyHardware WARRANTIES EXCLUSIVE LIMITATION OF LIABILITYFCC Warning TrademarksCopyright Statement CE Mark WarningPage PREFACE TABLE OF CONTENTSCHAPTER 2 INSTALLATION CHAPTER 1 OVERVIEW10/100Mbps Mode Operations Port APPENDIX A SPECIFICATIONSAPPENDIX B CONNECTOR PINOUTS viiiPurpose PREFACEAudience Appendix A Specifications Manual OrganizationChapter 2 Installation Appendix B Connector Pinouts2 OVERVIEW IntroductionProduct Features Packing ListFront Panel Figure 1 10/100 Fast Ethernet Switch Front PanelPorts Port 1 3-in-1 Combo Port 2 10/100Mbps, N-Way UTP/STP Table 1 Port and Cable SpecificationsConnector Port∙ Power LED LED IndicatorsFigure 2 LED Indicators ∙ Link/Act LED∙ 100M LEDs Duplex Mode SwitchRear Panel ∙ FDX/Col Collision LEDOverview 3 INSTALLATION Installation SiteFigure 4 Installing the 10/100 Fast Ethernet Switch on a Level Installing on a Desktop or ShelfSurface 10/100 Fast Ethernet Switch User’s Guide Installing on a WallFigure 5 Installing the 10/100 Fast Ethernet Switch on a Wall InstallationFigure 6 Connecting Power Connecting PowerNetwork Connections 10 & 100Mbps Mode Operations Port Setting the Duplex Mode10/100Mbps Mode Operations Port Figure 7 Setting the Duplex Mode Installation10/100 Fast Ethernet Switch User’s Guide Network Configuration ExamplesFigure 8 Connecting a 100Mbps LAN Segment to a 10Mbps LAN Segment InstallationFigure 9 Connecting a 100BASE-T Hub for Server Access InstallationPort 4 SPECIFICATIONSStandards Compliance PortPerformance Figure B-1 100BASE-TX Connector 5 CONNECTOR PINOUTSRJ-45 Connectors 10/100 Fast Ethernet Switch User’s GuideSignal Table B-1 100BASE-TX Connector PinoutsFigure B-2 Crossover Cable A schematic for crossover cables is shown in the following figureTable B-2 AUI Connector Pinouts AUI Transceiver ConnectorCircuit Offices TEL 886-2-916-1600 FAX Registration Card Print, type or use block lettersPage