D-Link DMP-CD100 user manual Power Supply, Rechargeable Nickel Cadmium Battery Installation

search or folder search may not be performed smoothly. You should not write non-MP3 files or unneeded folders along with MP3 files on the CD.

POWER SUPPLY

RECHARGEABLE NICKEL -

CADMIUM BATTERY

INSTALLATION

1.Remove the battery compartment cover by sliding the cover away from the DMP-CD100.

2.Insert the rechargeable

nickel-cadmium battery into the battery compartment. Be sure to observe the proper polarity (The + and - signs, as indicated inside the battery compartment).

NOTE: Fully charge the rechargeable nickel - cadmium battery before using it for the first time.

3.Close the battery compartment.

4.Plug one end of the supplied AC adaptor into the DC jack. Then plug the other end into an AC wall outlet.

5.When charging is completed, disconnect the AC adaptor plugs from both the DMP-CD100 and the AC outlet.

NOTE:

∙The battery takes approximately 10-15 hours after the AC adaptor is connected to be fully charged.

∙The indicator on the right side of the DMP-CD100 will light on during charging.

∙Use the DMP-CD100 with the supplied AC adaptor. Using with other AC adaptors could damage the DMP-CD100.

∙The DMP-CD100 can be powered up by using the AC adaptor alone without batteries.

NICKEL-CADMIUM (NICAD) BATTERIES

2