Dacor AOCTK27 Exhaust Duct Assembly Installation, Cabinet Or Wall Opening

STEP 1 CABINET OR WALL OPENING

CABINET OR WALL OPENING

Provide an opening in the wall or cabinet as indicated on

figure 1. The depth should be a minimum of 24". The fl oor of the opening should be constructed of plywood strong enough to support the weight of the oven (about 100 lbs.) and should be level for proper operation of the oven.

Note: While the proper functioning of the oven does not require that the opening be enclosed (with sides, ceiling and rear partition), this may be required by local code, and it is suggested that the local code be checked for any such requirement.

ELECTRICAL OUTLET LOCATION

This outlet should not be located in the shaded area of fi gure

1.At the rear of the opening, provide a 3-pronged, polarized, electrical outlet, 115-120 volt A.C., 15 amp. or larger.

Figure 1

5"

181/2 "

20 1 /8 11 1 /2 "

251 /4 "

STEP 2 EXHAUST DUCT ASSEMBLY INSTALLATION

1.Insert the edge of DUCT-B into the hold lip of DUCT-C. Secure together by using a SCREW-A provided in the kit. Remove the existing screw #1 at upper right rear of the oven and secure DUCT-C with the screw #1 just removed from the oven. Secure DUCT-B with SCREW-A through the duct and into the original screw hole in the oven. See fi gure 2.

2.Secure the EXHAUST DUCT ASSEMBLY with two SCREWS A. See Figure 3.

3.Position DUCT-A2 on top of the oven and insert it into the hold lip of DUCT-A1. Secure DUCT-A2 to DUCT-A1 using two SCREWS-A provided. See fi gure 4.

4.Position DUCT-A3 on top of the oven and insert it into DUCT-A2. Secure DUCT-A3 using three SCREWS-A provided.

Figure 2 Figure 3

DUCT-A1

DUCT-C SCREW-A

DUCT-B

DUCT-B

SCREW-A SCREW-A

SCREW-A

#1