Dacor DRT366S Burner Component Installation, SimmerSear Burner Assembly, Standard Burner Assembly, Grate Installation, STEP, STEP, STEP, STEP, STEP, tray, Spill, burner

Installation Instructions

Burner Component Installation

warning

•Never attempt to operate the cooktop with any of the burner parts removed.

•Do not attempt to adjust the burner air mixture settings. All adjustments are preset at the factory.

Remove the burner parts and grates from their shipping packages.

SimmerSear Burner Assembly

1.Install the SimmerSear burner ring(s) on top of the SimmerSear burner base(s). Line up the indentations on the bottom of the burner ring with the pins on the top of the burner base.

2.Set the outer SimmerSear burner cap(s) on top of the burner ring(s). Make sure the burner ring is centered on top.

3.Set the inner SimmerSear burner cap(s) on the center of the SimmerSear burner base(s). Line up the ridge on the bottom of the cap with the pins on the center of the burner base.

	Ridge on bottom
STEP 3	of inner burner cap
	Outer burner cap

STEP 2

Burner ring

STEP 1

Pin on burner

base

SimmerSear Burner Assembly

Ridge on bottom		Hole in burner ring
		goes over igniter
of burner cap
	STEP 2
	STEP 1	Burner ring
		Igniter
		Burner base
	Standard Burner Assembly

Standard Burner Assembly

1.Install the standard burner rings on the standard burner bases. There are two different sizes. Put the hole on the edge of each ring over the igniter. Center the tabs on the bottom of each ring in the hole in the center of each base.

2.Install all the standard burner caps. The ridge on the bottom of each cap must surround the top of each ring.

Grate Installation

Gently set the grates on top of the spill trays. Make sure that the rubber feet are positioned in the dimples. On model DRT366S, the center grate is smaller than the other two.

SimmerSear
burner	Standard
	burner
	Spill
	tray

9