Installation Instructions

8.Find the gas regulator assembly shipped with the unit.

9.Make sure the regulator adjustment knob is turned all the way in the OFF direction.

10.Plug the end of the gas tubing leading to the wine dispensing system into the gas regulator assembly.

11.Remove the plastic cap from the top of the argon gas cylinder (must be ordered separately, see page 6).

12.Insert the top of the gas cylinder into the bottom of the gas regulator assembly and turn it clockwise until it is snug. Do not overtighten.

13.Turn the regulator knob in the ON direction until it stops.

14.Open the door on the front of the unit. Swing the spout cover to the up position.

15.Make sure the power switch, located on the left side of the bottle bay, is slid all the way down, to the OFF position.

16.Plug the power cord into the electrical outlet.

17.Slide the main power switch all the way up to the ON position.

Switch Positions

ON

RESERVED

NOT USED

OFF

For use by authorized service personnel only

Main Power Switch (under spout cover)

18.The unit will run through a series of self-tests, which will take several seconds. Once this process is completed, the blue lights on the control panel will come on, indicating that the wine dispensing system is ready for use. IMPORTANT: When the system is powered up for the first time, LOCKED will appear on the display. See Unlocking the Control Panel in the operation section of the use and care manual for unlocking instructions.

19.Push up on the spout cover release lever on the bottom of the spout cover. Hold the lever up as you lower the cover down into place. CAUTION: Do not push down on the spout cover without pushing up on the lever. Damage to the lever will result.

20.Once the spout cover is closed, close the bottle bay door. Push in slightly just above the lock until it snaps shut.

Regulator assembly

Argon

gas

cylinder

Spout cover release lever (on bottom of spout cover)

Regulator

adjustment

knob

Gas supply

line from wine

dispensing

system

8