Installation Instructions

Installation

warning

•To avoid personal injury, use only the included gas pressure regulator or a Dacor specified replacement.

•Do not use any power supply other than the one provided with the system or a Dacor approved replacement. Do not attempt to modify or bypass the power supply.

1.Before installation, make sure any access holes for the power cord and gas tubing have been drilled in adjoining cabinets as necessary to allow them to pass through to the electrical outlet and gas cylinder location.

2.Plug one end of the plastic gas tubing (provided) into the inert gas connector at the back of the wine dispensing system.

3.If required route the plastic gas tubing though any access holes drilled in the adjoining cabinets.

These connectors used by qualified service personnel only

Plastic gas

tubing

4.Plug the power cord (provided) into the power plug on the power supply (black rectangular box) mounted on the back of the wine dispensing system.

5.If required, route the power cord though any access holes drilled in the adjoining cabinets.

6.Make sure the cable coming from the power supply (opposite the power cord that connects to the wall) is connected to the Power Input connector on the back of the unit. Also, check to make sure that both of the micro-switches located on the back of the unit are in the up position.

7.Slowly and gently lift the unit up and back into the final location. As you do this, have someone gently pull the gas tubing and power cable through the access holes into the adjacent cabinets (if necessary). Exercise care to make sure that the wiring and tubing lines do not become damaged. Make sure the require 1” (2.5 cm) space is maintained above and below the unit.

continued...

Connect power

supply output

here

120 Vac

power cord

Power supply

Inert gas

connector

Connect to

120 Vac 60 Hz. electrical outlet

7