Dacor Re-installingthe Drawer, Towel Rack Installation

Installation Instructions

Re-installing the Drawer

1.Pull the drawer slides all the way out of the drawer opening.

2.Gently lower the drawer between the extended slides until it is suspended by them.

3.Slide the back of the drawer mounting brackets under the drawer mounting clips on the slides.

4.Push one side of the drawer down onto its locking tab, until the tab locks into place.

5.Repeat the same process on the opposite side.

6.Gently open and close the drawer to make sure that it is properly installed.

STEP 3: Slide mounting bracket under clip on slide

Clip on slide

Slide

STEP 4: Push front of drawer down until tabs lock into place

Towel Rack Installation

(OWD24 Only)

Model OWD24 is designed so that it can be used as a towel warmer if desired. Other models are not equipped for this application. To use model OWD24 as a towel warmer, you must install the towel rack included with the unit in the bottom of the drawer.

To install the towel rack:

1.Open the drawer completely.

2.Insert the towel rack into the drawer in the orientation shown below.

3.Use the clamp and screw included with the rack to attach it to the back of the drawer face as shown below. There is a hole for the screw in the back of the face plate near the bottom.

8