Installation Instructions
warning
•To avoid personal injury caused by the appliance falling forward when the drawer is opened, secure the chassis to the cabinet and support platform as instructed.
•Be certain that the power plug is disconnected from the electrical outlet before installation.
•Verify that the electrical supply matches the ratings found on the appliance data plate and the installation specifications before proceeding.
Remove the Drawer
Remove the drawer from the appliance to allow access to the mounting holes during installation, and to reduce weight:
1.Pull the drawer out to the fully open position.
2.Push in on the locking tab on one side as you pull the drawer up.
3.When the drawer comes loose from the slide, repeat the same process on the opposite side.
4.Grip the drawer on both sides and pull it free.
5.For safety, push both drawer slides into the drawer opening.
STEP 2: Push
locking tab
STEP 3: Pull up on front of drawer
Installing the Chassis
1.Grasp the warming drawer chassis on opposite sides and slide it partially into the cabinet opening. Temporarily support the chassis in place so that it will not tilt or fall.
2.From an adjoining cabinet, reach in behind the drawer and pull the power cord until the plug is next to the electrical outlet. Do not plug in the power cord at this time.
3.After positioning the power cord and plug, slide the chassis completely into the cabinet until the front frame is positioned flush against the cabinet face.
4.Use the screws provided to secure the warming drawer chassis to the cabinet and support platform, insert them into the mounting holes and tighten into place. You may want to drill pilot holes prior to installing the mounting screws.
Mounting hole, 9 places
Mounting Hole Locations - ERW, EWD, IWD, MRW and
MWD Series Models
(IWD series models do not have a flange around
the edge of the faceplate)
Mounting hole, 4 places
Mounting Hole Locations -
OWD24
Continued...
Style varies, EWD27 shown
7