Installation Instructions
IMPORTANT:
•If you receive a damaged product, immediately contact your dealer or builder. Do not install or use a damaged appliance.
•Read all directions before you begin.
Unpack the Refrigerator
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not completely installed.
Keep doors taped closed until refrigerator is completely installed.
Use two or more people to move and install refrigerator.
Failure to do so can result in death or serious injury.
IMPORTANT:
•Do not remove the film on the outside until the refrigerator is in its operating position.
•Remove tape and glue residue from surfaces before turning on the refrigerator. Rub a small amount of liquid dish soap over the adhesive with your fingers. Wipe with warm water and dry.
•Do not use sharp instruments, rubbing alcohol, flammable fluids or abrasive cleaners to remove tape or glue. These products can damage the surface of your refrigerator. For more information, see Important Safety Instructions.
•Dispose of/recycle all packaging materials.
•After you remove all of the packaging materials, clean the inside of your refrigerator before using it. See Care and Cleaning in the use and care manual.
Move Refrigerator into House
WARNING
Tip Over Hazard
Refrigerator is top heavy and tips easily when not completely installed.
Keep doors taped closed until refrigerator is completely installed.
Use two or more people to move and install refrigerator.
Failure to do so can result in death or serious injury.
1.Place an appliance dolly under the left side of the refrigerator as shown. Be sure to avoid damaging the side trims and handles. Place the corner posts from the packing materials over the trims and handles as appropriate. Slowly tighten the strap.
NOTE: Pass the dolly strap under the handle for EF36 series models.
2.Place pieces of the shipping carton on the floor when rolling the dolly and refrigerator into the house. Move the refrigerator close to the opening.
3.Place cardboard or plywood under refrigerator.
4.Stand the refrigerator up. First, place the left bottom edge of the refrigerator on the floor, stand the refrigerator upright and then lower the
Door and Drawer Front Removal
Some installations require door and drawer front removal before transporting the refrigerator through doorways to the location where it will be used.
1.Unplug the power cord from the power source.
2. Remove the toe grille.
4