Installation Instructions
3.Remove the top hinge cover from the refrigerator door by removing the Phillips screw. Retain the screw and cover for later use. Hinge style may vary.
4.Unscrew the 5/16” hex head screws from the top hinge. Remove the hinge and retain it and all screws for later use.
5.On 3 door (french door) models, disconnect the wiring plug located on top of the left top hinge by wedging a
6.Lift the refrigerator door(s) from the center hinge pin.
7.Remove the Phillips screws that hold the center hinge in place. Remove the hinge and retain it and all screws for later use.
8.Pull the freezer drawer completely open.
9.Loosen the four (4) screws attaching the drawer brackets to the drawer front as shown.
NOTE: Loosen the screws only three to four turns. Do not remove the screws from the drawer front.
10.Lift the drawer front upward and off the screws.
11.Remove the rollers.
Hinge Cover Reinstalling the Door(s)
After the moving the refrigerator to the location where it will be used, reinstall the door(s) and freezer drawer front.
1. Replace the rollers.
Top Hinge 2. Slide the screws on the 
back of the drawer front
into the slots in the drawer brackets on both sides. You may need to move
the bottom of the bracket
around slightly to get the
Wiring Plug slot to line up with the screw.
3.Tighten the four front panel
screws completely. Do not
4.Install the top hinge loosely using the existing 5/16” hex head screws.
5. Install the center hinge using the existing Phillips screws.
Center
Hinge
Top Hinge | Center Hinge |
|
6.Place the hinge side of the refrigerator
door on the center hinge pin.
7.While holding the refrigerator door
upright, tighten down the top hinge with a 5/16” hex head driver.
Hinge Pin
8. On 3 door (french door) models, reconnect the wiring plug located on top of the left top hinge.
| Wiring Plug |
9. Replace the top hinge cover using | Hinge Cover |
the existing Phillips screw. |
|
5