Installation Instructions
•Remove all packing materials from inside the drawer. DO NOT REMOVE THE WAVEGUIDE COVER, which is located on the top of the Microwave
•Remove the feature sticker, if there is one. Check the drawer for any damage, such as misaligned or bent drawer, damaged drawer seals and sealing surfaces, broken or loose drawer guides and dents inside the cavity or on the front side of the drawer. If there is
any damage, do | Sealing | |
not operate the | ||
Surface | ||
Microwave In- |
| |
Waveguide | ||
contact your dealer | Cover | |
| ||
or a DACOR |
| |
AUTHORIZED |
| |
SERVICER. |
|
Sealing
Surface
Oven
Cavity
Figure 5
ELECTRICAL OUTLETelectrical outlet location
5"
Figure 6The electrical requirements are a 120 volt 60 Hz, AC only, 15 amp. or more protected electrical supply. It is recommended that a separate circuit serving only this appliance be provided.
The drawer is equipped with a
NOTE:
If you have any questions about the grounding or electrical instructions, consult a qualified electrician or service person.
Figure 7A |
| ||
1. | Place the drawer adjacent to the wall | Parts Supplied | |
| or cabinet opening. Plug the power |
| |
| supply cord into the electrical outlet. |
| |
2. | Carefully guide the drawer into the |
| |
| prepared opening. Avoid pinching the | 4 Screws | |
| cord between the oven and the wall. | ||
| Figure 7B | ||
3. | Slide the drawer all the way until the | ||
|
mounting flange is flush with the face of the cabinet.
4. Open the drawer. Using the 4 holes on the drawer as a template, predrill the cabinet using a 1/16" bit. See
Figure 7A.5. Secure the drawer with the 4 screws supplied. See Figure 7B.
BEFORE YOU CALL FOR SERVICERead the BEFORE YOU CALL and operating instruction sections in your use and care manual. It may save you time and expense. The list includes common occurrences that are not the result of defective workmanship or materials in this range.
Refer to the warranty in your use and care manual for Dacor’s