Dacor Wine Steward/Beverage Cooler Temperature Control, Interior Light and Switch, Glass Shelves

Temperature Control

The operating temperatures of the appliance range from the low forties to the mid fifties.

Do not install the appliance where the temperature will go below 55°F (13°C) or above 90°F (32°C).

NOTES:

As with any refrigeration product, there is a slight temperature variance at different locations within the cabinet.

Temperatures at the bottom of the cabinet will be cooler than temperatures at the top of the cabinet.

Position your wine inventory accordingly (i.e. white wines in the cooler zones and red in the warmer zones).

When the temperature is adjusted, allow 24 hours for the unit to stabilize.

Beverage Cooler

To set the control, turn it to the midpoint setting (approximately 45ºF). Once the beverage cooler is loaded, allow at least 24 hours before making any adjustments to the initial setting.

Beverage Cooler Temperature Controls

Wine Steward

The RED WINE setting will provide a storage temperature of approximately 55ºF (13ºC), which is optimum for the storage for red wine.

The WHITE WINE setting will provide a storage temperature of approximately 45ºF (7ºC), which is optimum for white wine.

To set the control, turn it to the RED WINE setting. Once the bottles are loaded, allow at least 24 hours before making any adjustments to the initial setting.

Wine Cooler Temperature Controls

Interior Light and Switch

The interior light makes it easy to view your wine/beverage labels and enhances the display of your collection.

When the switch is in the OFF position, the light comes on only when the door is opened. When the switch is in the ON position, the light remains on continuously for your maximum viewing pleasure. For best viewing do not store a bottle on the top shelf directly under the light. Remember to turn off the light when it is no longer needed.

Glass Shelves

Tempered glass shelves in the beverage cooler unit are removable for easy cleaning or for storing larger items.

To remove a shelf, open the door completely to avoid potential damage to the gasket. Lift up on the back of the shelf slightly. Tilt the shelf to one side at an angle while pulling forward.

To replace a shelf, open the door completely to avoid potential damage to the gasket. Tilt the shelf to one side at an angle and slide toward the back wall, placing one side onto the shelf support. Place the other side onto the opposite shelf support. Ensure rear locking tabs are engaged. When installed properly, the shelf will not slide forward when gently pulled.

To remove, lift up on the back of the shelf

Tilt the shelf at an angle while removing or replacing

Place in slots when replacing the shelf

Removing Full Extension Drawers

The bottom full extension drawers pull out so bottles can conveniently be added or removed.

The upper full extension slide can be removed for magnums or larger bottles.

To remove:

1.Pull the full extension drawer out to the STOP position.

2.Push the tab on right drawer guide down while pulling the tab on left guide up, and pull the drawer out.

To replace:

1.Push the drawer slide arm back into the unit.

2.Pull the small slide sub assembly completely forward.

3.Insert the sides of the drawer back into the guides.

4.Push until the tabs lock into place.

Tab (push tab down on right drawer guide, pull tab up on left drawer guide)

To replace, push drawer slide	Pull small slide sub assembly
arm back into unit	completely forward

NOTE:

Make sure the tabs on the full extension drawer guides are fully engaged before loading any bottles. Pull the drawers out all the way to the STOP position and push back in several times to make sure locking tabs are properly engaged.

2