24
Channel searching
- Select the “Frequency” function.
- Press, and hold for more than 1second, the remote control CURSOR RIGHT (A20) LEFT (A7)
buttons to start up [down] manual tuning.
- Searching will stop automatically at the next channel found (to stop tuning, press the re-
mote control MENU button (A19).
Note:
You can directly locate a program by entering the data into the “channel” or the “fre-
quency” function.
Enter station name
It is possible to enter your own choice of name for each program. You can change an existing
name, or enter a name where none exists. If none exists “- - - - - - -” will be shown in the Install
menu, and program status display.
- Select the “NAME” function.
- Select one of the 7 character positions by using the remote control CURSOR RIGHT (A20) /
LEFT (A7) buttons to move the cursor.
- Then use the CURSOR UP (A6) /DOWN (A21) buttons to select the desired character for that
position.
- Repeat the last two instructions for other positions, as desired.
- Once the name has been entered, press the OK button (A18) to store it. The name will be
memorised to the program number currently shown on the “Store To” line. The “Store To”
program number will highlight in red briefly.
TV system modification
If necessary, you can modify the TV system :
- Select “system” function.
- Adjust choosing between FRANCE (L/L’), GB (I), EURO (B/G), E/ EURO (D/K) systems. Then, the
program displayed on the screen is changed to the chosen system.
Perform fine tuning
- If you are unable to get a good picture or reasonable quality sound due to poor reception, it
is possible to perform fine tuning.
- Select the “frequency” function.
- Press, for less than 1 second, the remote control CURSOR RIGHT(A20) [LEFT(A7)] buttons to
perform up [down] fine tuning in steps of 0.05MHz (50 kHz).
Store program in memory
- Select the “store to” function
- Enter the program number you want to store to either by using the remote control CURSOR
RIGHT (A20) / LEFT (A7) buttons, or directly by using the remote control NUMBER 0...9 but-
tons (A3).
- Press the OK button (A18) to confirm.
Remarks:
this function can also be used if you want to copy a program already memorised
to another program number.