INSTALLATION INSTRUCTIONS
Removing transit bolts
1.Before operating the washer, remove the transit bolts(3ea) along with the rubber.
•If the bolts are not removed, it may cause heavy vibration, noise and malfunction.
3. Close the holes with the cap holders supplied.
2.Unscrew the 3 bolts with the spanner supplied. Keep the 3 bolts and spanner for future use.
•Whenever the appliance is transported, the transit bolts must be refitted.
Location of washer
•Check location where the washer will be installed. Make sure you have everything necessary for correct installation.
• Do not place or store your washer below 0°C (32°F) to | Drain Hose | |
| ||
avoid any damage from freezing. | Washer | |
• Do not place or store laundry products on top of washer |
| |
at any times. |
| |
• Install the washer on the horizontal solid floor. |
| |
If the washer is installed on an unsuitable floor, it could | Laundry | |
make considerable noise, vibrate severely and cause a | ||
Tub | ||
malfunction. If the washer is not level, adjust leg up or | ||
down for horizontal installation. | approx. | |
• Leave some space (right & left : 2cm, rear : 10cm). | 2cm |
4
