INLET HOSE CONNECTION

In using only one water tap or in case of only one water inlet valve, connect the inlet hose to the cold water inlet valve.

Option : Be careful not to confuse hot water inlet and cold water inlet.

For Ordinary Tap

1Pull down the collar of the

2Loosen the four screws

3Fit the water tap adapter

inlet hose to separate it

properly in order to fit into

into the water tap and

from the water tap

water tap.

tighten the four screws

adapter.

 

evenly while pushing up

 

 

the adapter so that the

 

 

rubber packing can stick

 

 

to the water tap tightly.

 

 

TAPE

4Remove the tape, and

5Connect the inlet hose to

6Connect the inlet hose

screw connector B into

the water tap adapter by

adapter of the hose to the

connect A tightly.

pulling down the collar of

water inlet of the washer

 

the hose end.

by turning it clockwise to

 

 

be fixed tightly.

Connector A

Connector B

• Please check the rubber packing present inside the inlet hose adapter of the hose.

For Screw-Shaped Tap

1Connect the inlet hose to the water tap by screwing the connector tightly.

Rubber

ConnectorPacking

Hose Connector

2Connect the connector- inlet supplied if necessary.

Connector inlet

Rubber

ConnectorPacking

Hose Connector

3Connect the inlet hose adapter to the water inlet of a washer and turn it to be fixed.

*Check the packing in the inlet

5

Page 5
Image 5
Daewoo DWD-F1213'S, DWD-F1013'S, DWD-F1211, DWD-F1212 Inlet Hose Connection, For Ordinary Tap, For Screw-Shaped Tap