Symptom | Check |
|
|
No TV / Video displayed | Check TV/Video Mode has been set using the SOURCE button. |
| Check Video cable terminal is connected |
Unclear TV display | Check connection status of TV cable, exterior Antenna and adjust |
| FINE TUNING from TV OSD menu if necessary |
No TV signal | Auto Search from TV OSD menu and set Edit channel or search |
| channels manually with MANUAL SET ON from TV OSD menu |
Remote Controller not | Check batteries are correctly inserted [+] and |
functioning | Check battery power status |
No Video or | Check Video cable is connected to the TV and set to Video mode or |
| |
|
|
Poor colour in Video | Adjust Saturation on the OSD menu in PICTURE mode |
|
|
Blurred picture in Video | Adjust Sharpness in the OSD menu in PICTURE mode |
|
|
Picture jitter (PC mode) | Adjust clock to set the screen position and adjust until no noise is |
| detected in the OSD Menu in PICTURE MODE |
No picture (PC mode) | Check mains switch and the PC power switch are ON |
Power LED not lit (PC | Check main switch is ON. Check if the power cord is connected |
mode) |
|
Image is unstable (PC | Check signal cable is connected to video card correctly |
mode) |
|
Image not centred, too small | Adjust clock or H&V Centre |
or too large (PC mode) |
|
Picture bounce or wave | Magnetic interference from electrical devices are too close to the |
pattern (PC mode) | monitor |
|
|
Picture is blurred (PC mode) | Adjust contrast and brightness |
|
|
| Check audio cable is connected correctly. Adjust volume. Check |
No sound (PC mode) | audio system on PC |
| Adjust the volume on the OSD Menu or adjust the volume on the |
Low sound (PC mode) | sound card of the PC |
17
