|
|
|
Wiring: |
|
|
RED | - | connect to fused, switched 12 volt power. (An accessory terminal will work for this.) |
ORANGE | - | connect to fused, constant battery power. |
BLUE | - | Night Dimming: connect to the head light switch. |
BLACK | - | connect to a main ground location |
Mounting:
The gauge requires an oval hole
Operation:
The gauge needs the red, orange, and black wires connected to operate. The red wire should have switched 12 volt power from an ACC. point on the fuse panel. The orange wire should have constant 12 volt power. The black wire should be connected to a good ground point. When the blue wire has 12 volts, it will dim the display for night viewing.
Setting the time:
Using a small, thin object such as a toothpick or pin, press “set” buttons through front lens access holes. The access holes are on the left and right sides of the lens. Left “set” button advances hours, right “set” button advances minutes. Each time that you make a change to either the hours or minutes, the seconds are reset to zero.
Adjusting the accuracy:
The clock is accurate to
Press the minute set button to change the cal value. Press the hour set button to return to normal clock operation.
MAN# 650142