OPTION – DIM OUT
The dim out option allows the dim output to be turned on or off. The dim output is used if you have installed other Dakota Digital gauges and would like this gauge to also control the dimming of these gauges. If the dim out option is turned on, 12v is sent out on the dim out wire when the gauge is dimming. In this mode, the gauge will be either in dim mode or full brightness mode.
If no other gauges are to be dimmed, this option can be set to off. In this mode the gauge will fade when dimming and gauge dimming will be less noticeable.
TROUBLESHOOTING
PROBLEM | CAUSE | SOLUTION |
Gauge does not light up | Gauge has bad ground or power | Check connections to wiring harness and check |
|
| wiring harness and gauge wires for pinched or |
|
| broken wires. |
Speed reads incorrectly | Speedometer needs to be recalibrated | See setup for speed calibration instructions. |
Gauge does not dim | Dim level is set to off or set too low | Set dim level to higher level (see setup) |
Gauge is always dim | Dim level is set too high | Set dim level to lower level (see setup) |
| Light sensor over left switch is covered | Make sure left side of lens is not covered. |
is displayed in fuel or | No sender connected. | Check proper connection to sender. Check for |
oil display |
| broken or pinched sensor wires. |
is displayed in fuel or | Sensor wire is shorted to ground. | Check sensor wire harness for correct connection |
oil display. |
| to sensor. Check for pinched or broken sensor |
|
| wire harness. |
SERVICE DUE is scrolled | One of the countdown service meters | Perform service and reset service meter by |
in the message center | has reached zero | holding right switch when service meter is |
|
| displayed. If service meter operation is not |
|
| desired, disable service meter by setting to in |
|
| the setup menu. |
ERR 01 to ERR 99 is | The Rhino engine computer is sending | See your Yamaha dealer for appropriate service. |
displayed in the message | error codes to the gauge. |
|
center |
|
|
ERR B.1is displayed in | Gauge has poor bus connection to | Check for good connection to gauge harness. |
message center | Rhino engine computer. |
|
ERR B.2is displayed in | Bus wire is always in high state. | Check for shorts to 12V on bus wire. |
message center | Gauge bus circuit damaged. | Repair needed. |
| ||
ERR B.3is displayed in | Bus wire is shorted to ground. | Check for shorts to ground on bus wire. Check for |
message center |
| proper connection to Rhino harness. |
GAUGE WIRE COLOR CHART
VIOLET / BLACK | Data bus |
BLACK / RED | Keyed power |
WHITE / BLUE | Ground |
WHITE | Fuel sender |
GREEN / BLUE | Constant power |
page 5 | MAN#650244:A |
