OPERATING INSTRUCTIONS
To avoid vibration, the unit must be set level. This is accomplished by adjusting the (1) front leveling leg located under the refrigerator. The temperature of the refrigerator is controlled by setting the thermostat knob to a desired setting.
TEMPERATURE SELECTION
To start the refrigerator, turn the temperature control knob to the position corresponding to the desired cooling (on the graduated blue dial) in Fig. A. The refrigerator temperature will vary depending on the quantity of the food stored, and on the frequency with which the door is opened.
The refrigerator temperature will vary depending on the quantity of the food stored and on the frequency with which the door is opened.To turn the control to the “OFF” position, rotate the control knob to the “0” setting. After defrosting and if the refrigerator has been left out of use for some time, set the control to maximum for 2 to 3 hours before turning to the desired position. If the refrigerator is not to be used for long time periods, disconnect the plug and leave the door partially open. This will help reduce the mold/mildew from accumulat- ing inside the refrigerator cabinet.
Fig. A
CARE AND MAINTENANCE
DEFROSTING
This refrigerator is equipped with a “Push Button”
NOTE: If the “Push Button” is
Defrosting of your refrigerator should take place
whenever ice
Important: You must remember to close the refrigerator door before the defrost cycle terminates and normal operating conditions resume automatically. The drip tray should be in position directly below the freezer compartment to catch con- densed water during defrosting.
Note: Never use sharp or pointed instruments to remove ice from the freezer compartment. The freezer compartment contains refrigerated gas lines and if accidentally punched/pierced, will render the refrigerator inoperable and void the manufacturers warranty.
DO NOT ALLOW THE REFRIGERATOR TO CONTINUE
OPERATION IF THE FREEZER COMPARTMENT IS
PIERCED.
After defrosting is complete, set the control to maximum for 2 to 3 hours before returning to the desired position. When the refrigerator is not to be used for a long period of time, discon- nect the appliance from the electrical supply and leave the door partially open. This will help to reduce mold and mildew
Note: Wait 3 to 5 minutes before attempting to restart the refrigerator if operation has been interrupted.
4