OPERATING INSTRUCTIONS
To avoid vibration, the unit must be set level. This is accomplished by adjusting the (1) front leveling leg located under the refrigerator. The temperature of the refrigerator is controlled by setting the thermostat knob to a desired setting.
TEMPERATURE SELECTION
To start the refrigerator,turn the temperature control knob to the position corresponding to the desired cooling (on the graduated black dial) in Fig.A. The refrigerator temperature will vary depending on the quantity of the food stored, and on the frequency with which the door is opened.
To tum the control to the OFF" position, rotate the control |
|
knob to the "0" setting. After defrosting and if the refrigerator |
|
has been left out of use for some time, set the control to |
|
maximum for 2 to 3 hours before turning to the desired posi- |
|
tion. If the refrigerator is not to be used for long time peri- |
|
ods, disconnect the plug and leave the door partially open. | IFig.AI |
This will help reduce the mold/mildew from accumulating | |
inside the refrigerator cabinet. |
|
CARE AND MAINTENANCE
DEFROSTING
Defrosting of your refrigerator should take place
whenever ice
Note: Never use sharp or pointed instruments to remove ice from the freezer compartment. The freezer compartment contains refrigerated gas lines and if accidentally punched/pierced, will render the
refrigerator inoperable and void the manufacturers warranty.
DO NOT ALLOW THE REFRIGERATOR TO CONTINUE
OPERATION IF THE FREEZER COMPARTMENT IS
PIERCED.
After defrosting is complete, set the control to maximum for 2 to 3 hours before returning to the desired position. When the refrigerator is not to be used for a long period of time, discon- nect the appliance from the electrical supply and leave the door partially open. This will help to reduce mold and mildew
Note:Wait 3 to 5 minutes before attempting to restart the refrigerator if operation has been interrupted.
5
