OPERATING INTRUCTIONS (cont’d)
DOOR REVERSAL
INSTRUCTIONS
1)Unplug the unit from electrical outlet (if connected) and lay it on its back.
2)Open the door until the screws securing the lower door support bracket are exposed on the bottom of the door (Fig. 2)
3)Remove the screw that is closest to the hinge assembly and gently close the door to remove the remaining screw from the support bracket.
4)Swing the door slightly towards the left side in order to remove the support bracket from the door and the lower hinge assembly.
5)Pull the door downward to remove it from the cabinet of the wine cooler.
6)Remove the cap from the top left side of the door (Fig. 4) and reinstall it on the top right side.
7)Remove the three (3) screws supporting the top hinge (Fig. 1).
8)Remove the plastic caps from the left side of the frame (Fig. 3) and reinstall them on the right side of the frame (the previous hinge location).
9)Install the new left hand hinge assembly (supplied with unit) on the left side of the frame.
10)Insert the lower door support into the left side bottom hinge.
11)Carefully reposition the door firstly into the left side upper hinge assembly, then onto the lower door support bracket.
12)While the door remains closed, install the first screw into the lower support bracket.
13)Open the door and install the screw that is closest to the hinge assembly.
14)Close the door and return the unit to its upright position (wait 60 mins before reconnecting power to the wine cooler), verify the door allignment and proper seal against the cabinet.
Door Plug
Upper Hinge Assembly
Plastic Caps (3)
Fig 4
Fig 1
Lower Hinge Assembly
and Door Support Bracket
Fig 3
Fig 2
6
