Installation Instructions - Intergrated Application
Tools you will |
| |||
Need |
|
|
| |
|
| Safety Glasses | Level | |
|
| Gloves | ||
FOR YOUR SAFETY: |
| |||
While performing installa- | Flashlight | |||
tions described | in this | Carpenters | ||
section, | gloves, | safety | Square | |
glasses or goggles should | Measuring | |||
Tape | ||||
be worn. |
|
| ||
| Drill & Hole Saw set | |||
|
| |||
Preparing the Enclosure
Electrical
Requirements:
The appliance must be connected to an individual properly grounded electri- cal outlet, protected by a 15 or 20 ampere circuit breaker or time delay fuse.
•It is recommended that you do not install the wine cooler into a corner (i.e. directly beside a wall). This is to allow the door to have a greater then 90° opening swing. A limited door swing will prevent the shelves from sliding out as intended, and may lead to damaging the door gasket.
•The rough cabinet opening must be on a level floor area and at least 24” deep by 24” wide. The opening should also have a height of at least 34 3/4”.
•The electrical oulet may be positioned from within either side of the adjacent cabinetry, or the rear of the shaded area (as shown in Fig E).
•If the electrical outlet is locat- ed inside the adjacent cabi- netry, cut a
34 3/4”
From
Underside
of
Countertop
to Floor
cabinetry 
24”
Min.
2”
Electrical Access
6”
24”
Cabinets
Square
and
Plumb
Fig E
8
