Dantax LR-7500 manual Tuner Operation, Station Selection, Tuner-Mode, Preset Memory

Tuner Operation

TUN/PRE

SELECT

SOURCE

AM/FMT.MODE

The LR-7500's tuner is capable of tuning AM,FM and FM Stereo broadcast stations. Stations may be tuned manually, or they may be stored as favorite station presets and recalled from a 50-position memory.

Station Selection

1Press the AM/FM button on the remote controller to select the tuner as an input

or

The tuner may be selected from the front panel by either pressing the SOURCE (6/n) buttons until the tuner is active or by pressing the AM/FM button.

2Pressing the AM/FM button or the AM/FM button on the front panel again to switch between AM and FM so that the desired frequency band is selected.

3Press the T.MODE on the front panel (or the TUN-M but- ton on the remote controller) to select manual or auto- matic tuning.

4Select "AUTO TUNING" and each press of the TUNING(v/^) button (or TUN/PRE button). Then put the tuner in a scan mode that seek the next higher or lower frequency station with acceptable signal strength.

•Select "MAUNAL TUNING" and each press of the TUN- ING(v/^) button (or TUN/PRE button). The frequency increases or decreases by one increment.

5Stations may also be tuned directly. To enter a station's frequency directly, first select the AM or FM. Next, press the DIRECT button on the remote controller and enter the station frequency by pressing the Numeric buttons.

NUMERIC AM/FM

TUNING	TUN-M DIRECT
PRESET	MEMO

Tuner-Mode

Pressing the TUN-M button on the remote controller alternates between Stereo mode and Mono mode.

- STEREO

FM stereo broadcasts are received in stereo and the STEREO indicator lights in the display.

- MONO

To compensate for weak FM stereo reception, select this mode. Reception will now be forced monaural, reducing unwanted noise.

Preset Memory

You can preset a maximum of 50 favorite channels.

1Press the MEMO button. The two underscore lines will appear at the far right side of the display.

2Within 5 seconds, press the Numeric buttons corre- sponding to the location where you wish to store this station's frequency.

3Repeat the process after tuning any additional stations to be preset.

Recalling Preset Stations

•To manually select a station previously entered in the pre- set memory, press the Numeric buttons that correspond to the desired station's memory location.

•To manually tune through the list of stored preset stations one by one, press the PRESET(v/^) button or the remote controller or the TUN/PRE (6/n) button on the front panel.

- 21 -