Datalogic Scanning PBT7100 Statement of Agency Compliance

Statement of Agency Compliance

This device complies with part 15 of the FCC Rules. Operation is subject to the following two con-

ditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

The user is cautioned that changes or modifications not expressly approved by the part responsible

for compliance could void the user’s authority to operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses, and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause harmful inter-

ference to radio or television reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one or more of the following mea-

sures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver

is connected.

• Consult the dealer or an experienced radio or television technician for help.

This equipment complies with FCC radiation exposure limits under Specific Absorption Rate

(SAR) tests for portable devices operating closer than 20 cm to nearby persons, set forth in an

uncontrolled environment. The reader has been demonstrated to meet these RF emissions safety

limits.

This equipment does not exceed the Class B limits for radio noise emissions as described in the

Radio Interference Regulations of the Canadian Department of Communications.

Le present appareil numerique n’emet pas de bruits radioelectriques depassant les limites applicables

aux appareils numeriques de la classe B prescrites dans le Reglement sur le brouillage radioelectrique

edicte par le ministere des Communications du Canada.

The reader is rated as IEC 529-IP65. This nomenclature designates the degree of water and dust

resistance, indicating the imager is totally protected against dust and is protected against low pres-

sure jets of water from all directions - limited ingression permitted.

The Base Station is rated as IEC 529-IP54, indicating the unit is protected against dust, limited

ingress (no harmful deposit) and is protected against water sprayed from all directions - with limited

ingression permitted.

Models require either a Listed class II or class III with a Limited Power Source (LPS). For the safety certification to be

valid, class III input power sources must be IEC/EN60950-1 (EN 60335-series, EN 60065 or relevant)

approved.

Input: 100 - 240 VAC Output: 5.2 VDC

Max. Current: 2.4 A Max. Power: 12.5 W