Dayton 3VG79A Preventative Maintenance Schedule, STORING, TRANSPORTING, or SHIP- Ping

Dayton Operating Instructions and Parts Manual

Model 3VG79A

Maintenance (Continued)

5.Remove pump plate.

6.Remove rotor, insert, and blades.

7.Check for debris in pump. If debris is found, blow out with compressed air.

8.Install insert and rotor.

9.Check gap on rotor. Adjust to

.003"/.004" if needed (See Figure 19).

Blade Gap Adjusting Screw

.003"/.004" Gap

Measured With

Feeler Gauge

Rotor

Gap Adjusting Screw

11.Replace fan guard and upper shell.

12.Adjust pump pressure (See page 6).

NOTE: If rotor is still binding, proceed as follows.

13.Perform steps 1 through 6 above.

14.Place fine grade sandpaper (600 grit) on flat surface. Sand rotor lightly in “figure 8” motion four times (See Figure 20).

Sandpaper

STORING, TRANSPORTING, OR SHIP- PING

NOTE: If shipping, transport companies require fuel tanks to be empty.

1. Drain fuel tank.

NOTE: This model has a drain plug on underside of fuel tank. Remove drain plug to drain all fuel. Be sure all fuel is removed.

2. Replace drain plug.

3. If any debris is noted in old fuel, add 1

or 2 quarts of clean Kerosene to tank,

stir, and drain again. This will prevent

excess debris from clogging filters

during future use.

4. Replace fuel cap and drain plug.

Properly dispose of old and dirty fuel.

Check with local automotive service

stations that recycle oil.

Figure 20 - Sanding Rotor

Figure 19 - Gap Adjusting Screw Locations

15. Reinstall insert and rotor.

NOTE: Rotate rotor one full turn to insure

the gap is .003"/.004" at tightest position. 16. Perform steps 10 through 12 above. Adjust if needed.

10.Install blades, pump plate, air filters, and filter end cover.

5. If storing, store heater in dry place.

Make sure storage place is free of dust

and corrosive fumes.

IMPORTANT: Do not store Kerosene over summer months for use during next heating season. Using old fuel could damage heater.

Preventative Maintenance Schedule

Never service heater while it is plugged in, operating, or hot. Severe burns and electrical shock can occur.

Item	How Often	How To
Fuel tank	Flush every 150-200 hours of operation or as needed	See Storing, Transporting, or Shipping,
		above
Air output and	Replace every 500 hours of operation or once a year	See Air Output, Air Intake, and Lint
lint filters		Filters, page 6
Air intake filter	Wash and dry with soap and water every 500 hours of	See Air Output, Air Intake, and Lint
	operation or as needed	Filters, page 6
Fuel filter	Clean twice a heating season or as needed	See Fuel Filter, page 7
Spark plug	Clean and regap every 600 hours operation or replace as needed	See Spark Plug, page 7
Fan blades	Clean every season or as needed	See Fan, page 6
Motor	Not required/permanently lubricated
		®
	9

Version B - For Reduction G016.J