Dayton Operating Instructions and Parts Manual | 3VG80 |
Dayton® Propane
Construction Heater
Ventilation
Follow the mini- mum fresh, outside
air ventilation requirements. If proper fresh, outside air ventilation is not provided, carbon monoxide poisoning can occur. Provide proper fresh, outside air ventilation before running heater.
Provide at least a
Installation
Review and understand the
warnings in the General Safety Infor- mation section, pages 2 and 3. They are needed to safely operate this heater. Follow all local codes when using this heater.
Test all gas piping and connections
for leaks after installing or servicing. Never use an open flame to check for a leak. Apply a mixture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks at once.
1.Provide propane supply system (See Propane Supply, page 5).
2.Connect fuel gas connector fitting on hose/regulator assembly to propane tank(s). Turn counterclockwise into threads on tank valve. Tighten firmly using wrench.
IMPORTANT: Tighten regulator with vent pointing down. Pointing vent down protects regulator from weather damage.
Hose
Supply | Fuel Gas | |
Connector | ||
Valve | ||
|
Propane | Regulator |
Tank |
Vent
(pointing down)
Figure 4 - Regulator With Vent Pointing Down
3.Connect hose to inlet connector. Tighten firmly using a wrench.
IMPORTANT: Extra hose or piping may be used if needed. Install extra hose or piping between hose/regulator assembly and propane tank. You must use the regulator supplied with heater.
100,000 Btu/Hr
Model Shown
Inlet Connector
Hose
Figure 5 - Hose and Inlet Connector
4.Open propane supply valve on propane tank(s) slowly.
NOTE: If not opened slowly,
5. Check all connections for leaks.
Never use an open flame to check for a leak. Apply a mixture of liquid soap
and water to all joints. Bubbles forming show a leak. Correct all leaks at once.
6. Close propane supply valve.
Operation
Review and understand the
warnings in the General Safety Infor- mation section, pages 2 and 3. They are needed to safely operate this heater. Follow all local codes when using this heater.
TO START HEATER
1.Follow all installation, ventilation and safety information.
2.Locate heater on stable and level surface. Make sure strong drafts do not blow into front or rear of heater.
3.Make sure the control knob is in the OFF position.
4.Plug power cord of heater into a three- prong, grounded extension cord. Extension cord must be at least two meters (six feet) long, UL/CSA listed, and of a proper size.
EXTENSION CORD WIRE SIZE REQUIREMENT
Up to 100 feet long, use 16 AWG rated cord.
101 to 200 feet long, use 14 AWG rated cord.
6
