dbx Pro Rear Panel and Connections, Rear Panel Operation Connections, Compressor Limiter2625

Rear Panel and Connections

is the master, and Channel 2 is the slave. Each of the Channel 2 controls and switches will be overridden and controlled by Channel 1 except the Bypass switch which will remain independent. Also, Channel 2’s 3-LED Threshold Meter will be disabled, while both channels’ Gain Reduction Meters will identically indicate the amount of gain reduction occurring. It is important to note that while Channel 1 is the master as far as the controls go, both channels have equal precedence as far as signal processing is concerned. The 262 uses True RMS Power Summing™, an extremely accurate and musical way to combine detector outputs in a stereo situation. The LED adjacent to the switch will be lit when switched to stereo couple mode.

15WATTS￿

￿

100V 50/60Hz￿

120V 60Hz￿

￿

¨

PROFESSIONAL PRODUCTS

A HARMAN INTERNATIONAL￿ COMPANY￿

SALT LAKE CITY, UTAH￿ MADE IN USA￿ MODEL 262￿

￿

CHANNEL TWO		CHANNEL ONE
OUTPUT	INPUT	OUTPUT	INPUT
C A U T I O N
RISK OF ELECTRIC SHOCK
DO NOT OPEN	BAL /￿		BAL /￿
A T T E N T I O N : RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
	UNBAL		UNBAL
W A R N I N G : TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE

INPUT Jacks: The input jacks accept a standard 1/4” TRS phone plug for a balanced input source, or a standard 1/4” TS phone plug for an unbalanced source.

OUTPUT Jack: The output jacks accept a standard 1/4” TRS phone plug for dri- ving balanced lines, or a standard 1/4” TS phone plug for driving unbalanced lines.

AC Power Receptacle: This receptacle accepts an IEC-type power cord (as shipped with the unit). Check that the AC power markings below the AC power connector are correct for your area. (Either 100/120V, or 230V.) Plug the cord into the unit and mains power. Note that the 262 does not have a power switch. It is recommended that the 262 be “On” at all times. Power consump- tion is low. If you do not plan to use the 262 for an extended period of time, unplug it. Connection to an inappropriate power source may result in extensive damage which is not covered by the warranty.

The 262 has balanced inputs and outputs, and can be used with any line-level device. Some common examples include: mixing consoles, patch bays and other signal processors.

For all connections, refer to the following steps:

1.Turn off all equipment before making any connections.

2.Mount the 262 in a 1U rack space (optional).

The 262 requires one rack space (height). It can be mounted above or below anything that doesn’t generate excessive heat, since it requires no special venti- lation. Ambient temperatures should not exceed 113˚F (45˚C) when equipment

Rear Panel Operation

Connections

Compressor/

Limiter2625