DCS BGC-3036 Wall Mount Full Backguard Installation, Recommended Installation Order, Vent Hood

WALL MOUNT FULL BACKGUARD INSTALLATION

RECOMMENDED INSTALLATION ORDER:

1) VENT HOOD 2) BACKGUARD SYSTEM 3) COOKTOP

1.Locate and level cooktop per installation instructions.

2.After unpacking all backguard system parts, locate the Back Section 1/8” (see fig. 03) above and centered over the Trim attached to the cooktop.* Secure Back Section to wall with the appropriate fasteners (not supplied) to anchors or wood stud (fig. 03).

WARNING:

The Back Section must be securely fastened to the wall. Failure to do so could cause damage or personal injury if the Backguard was to pull free from wall when racks are loaded. The maximum weight placed on each rack should be 10 lbs.

*After 1/8” is located, slots in back section may be used to adjust spacing between cooktop trim and backguard for a flush fit.

3.Attach rod, end caps and center stanchion to Front Section of backguard with #10 machine screws supplied (fig. 04).

4.Bend wedge-shaped tabs down on top of the front section approximately 3/16”. When mounting the front section, insure that these tabs engage the mating holes in the top of the rear section (see fig. 05, page 5).

5.Secure Front Section of backguard to the Back Section with #8 self-tapping sheet metal screws supplied (fig. 05, page 5).

6.Attach racks to rod (fig. 06, page 5). The maximum weight placed on each rack should be 10 lbs.

Back Section

Slots to choose desired spacing between Cook- top Trim and Backguard.

16”for		30”
36”for
	36/48”

Trim

Fig.03

Bend down approx. 3/16”

Front Section

End

Cap

Center

Stanchion

#10

Machine

Screws

Rod

End

Cap

Fig.04

4